Toyota 84-89 4runner Pick Up Center Console Hinge Replacement Kit

This fits Single lid consoles and the lower hinge on a double stack console only.

Will not fit a single lid console with rear heater option check the other listing for that hinge kit. 

The new replacement hinge is made from aluminum with a 1/8 steel pin pressed in. 

Initially, I wanted to 3-D print them out of plastic but after some testing that didn’t work out so now they are made from  aluminum and will not be a weak point in the console. 

Missing the metal hinge or did the plastic hinge crack at the folding seam?  

Plastic Hinge lids  - I recommend ordering the cupholder lid i 3D print. Since your factory lid doesn’t have anywhere to mount a New hinge 

Your able to glue it with some jb weld I’m sure or use plastic screws but just a fyi your lid won’t have anywhere to bolt the hinge too.

Here is a straightforward fix: a 3D-printed aluminum hinge, a new rubber latch that flexes and folds rather than breaking off like the original latch, and two side supports to prevent the hinge from being overextending  This full kit is recommended for the double stack consoles  then you can go to the other listing and order just the hinge to complete the entire console . 

Taking pre orders Now depending on the amount of orders, I get, they should ship the second week of February.